104
BAS-SVX40K-EN
Figure 68. Other referencer
Note: "Pressure" is the atmospheric pressure used for CO
2
sensor calibration. It was mistakenly left
exposed in Synchrony v5.1 interface. It will be removed in a future revision of the SC+
firmware.
6. Make any other changes that are required such as alarm or limits settings and save the point.
7. The value of the sensor can now be used in TGP2, graphics or Data Logs
Figure 69. New point
Communication History
Overview
Communication History is a tool that will help a technician pinpoint when intermittent communication
and/or interference is occurring. This tool is only available when there is an SC+. Communication
Using the Tracer® TU Service Tool with a Wireless Network
To Next Page
Loading...
