Trane Air-Fi WCS-SB - Mounting the Sensor Back Plate

40
BAS-SVX40K-EN
Mounting the Sensor Back Plate
To mount the sensor back plate:
1. Hold the back plate against the mounting surface and mark the screw locations.
2. Secure the back plate against the mounting surface using included hardware.
The figure shows an example of mounting the back plate of the sensor into sheetrock or plaster.
Figure 30. Mounting the sensor back plate into sheetrock
Important: To comply with FCC and IC regulations, do not mount this sensor within 20 cm of any other
radio device including other WCS sensors.
WCS-SB/SD Installation