Trane IntelliPak Signature Series - Page 62

62
Programming
PKG-SVP01B-EN
(On units with hydronic, electric, or external heat)
For Unocc ZoneTemp Heating Control, Use
Setpoint From: HI (KEYPAD) SETPOINT MENU
Factory Presets: HI (Keypad) Setpoint Menu
Possible Values: HI (Keypad) Setpoint Menu
Zone Sensor Setpoint Menu
NSB Zone Sensor Setpoint Input
GBAS 0-5 VDC Module
1. Pressing the NEXT key will display the following screen.
(On units with hydronic, electric, or external heat)
For Morning Warmup Temp Control, Use
Setpoint From: HI (KEYPAD) SETPOINT MENU
Factory Presets: HI (Keypad) Setpoint Menu
Possible Values: HI (Keypad) Setpoint Menu
NSB Zone Sensor Setpoint Input
1. Pressing the NEXT key will display the following screen.
(On units with an airside or waterside economizer or VCM )
For Default OA Min Position, Use
Setpoint From: HI (KEYPAD) SETPOINT MENU
Factory Presets: HI (Keypad) Setpoint Menu
Possible Values: HI (Keypad) Setpoint Menu
Remote Min Pos Pot Input
1. Pressing the NEXT key will display the following screen.
(On units with a VCM and GBAS)
For Min Outside Air Flow Rate Ctrl, Use
Setpoint From: HI (KEYPAD) SETPOINT MENU
Factory Presets: HI (Keypad) Setpoint Menu
Possible Values: HI (Keypad) Setpoint Menu
GBAS 0-5 VDC Module
1. Pressing the NEXT key will display the following screen.
(On units with IGV or VFD and GBAS)
For Supply Air Pressure Control, Use
Setpoint From: HI (KEYPAD) SETPOINT MENU
Factory Presets: HI (Keypad) Setpoint Menu
Possible Values: HI (Keypad) Setpoint Menu
GBAS 0-5 VDC Module
1. Pressing the NEXT key will display the following screen.
End of Submenu (NEXT) to Enter SETUP
1. Pressing the NEXT key will display the following screen.
SETPOINT