BAS-SVN028K-EN 5
Equipment/Software Supported
The three zone sensor models are compatible with the
following HVAC equipment and control systems. The
sensor is designed for use with stand-alone space comfort
control equipment only. It is not designed for use in a
building automation system.
ReliaTel
The zone sensor controls Precedent™, Voyager™ 2,
Voyager 3, and Odyssey™ CV/SZVAV/Multi-speed indoor
fan equipment that uses the ReliaTel control system.
For proper operation, the ReliaTel RTRM board must be
installed in the equipment with software version 19.2 or
later. In addition, the BCI-R board must be installed with
software version 6.00 or later.
Multi-zone systems are not supported. In the field, Multi-
zone HVAC equipment can be identified by the presence of
the ReliaTel RTAM board installed in the equipment
Symbio 400
The zone sensor controls factory-programmed fan coil,
blower coil, and both staged and variable speed water
source heat pump equipment that uses the Symbio 400
control system. Field-programmed Symbio 400 controlled
equipment is not supported.
Symbio 700
The zone sensor controls any equipment that uses the
Symbio 700 control system. Multi-zone systems are not
supported.
Symbio 800
The zone sensor controls IntelliPak equipment that uses
the Symbio 800 control system.
To Next Page
Loading...
