Trane Tracer TD7

Tracer®TD7 Display
for the Tracer UC600 Programmable
Controller
Installation, Operation, and Maintenance
April 2020
BAS-SVX50F-EN
SAFETY WARNING
Only qualified personnel should install and service the equipment. The installation, starting up, and servicing of
heating, ventilating, and air-conditioning equipment can be hazardous and requires specific knowledge and training.
Improperly installed, adjusted or altered equipment by an unqualified person could result in death or serious injury.
When working on the equipment, observe all precautions in the literature and on the tags, stickers, and labels that are
attached to the equipment.

Trane Tracer TD7 Specifications

General

Category	Controller
Display	LCD
Connectivity	Wired
Power Supply	24 VAC/VDC
Communication Protocol	BACnet MS/TP
Operating Temperature	32°F to 122°F (0°C to 50°C)
Enclosure Rating	IP20
Product Type	Controller
Compatibility	Trane Tracer
User Interface	Touchscreen
Input Voltage	24VAC
Humidity Range	10% to 90% (non-condensing)
Memory	Non-volatile flash memory

Summary

Introduction and Safety

Warnings, Cautions, and Notices

Defines advisory types like WARNING, CAUTION, and NOTICE for user safety.

Hazardous Voltage Warning

Critical safety warning regarding electrical hazards during installation.

Alarms and Notifications

Active Alarms Display

Shows currently active alarms requiring attention.

All Alarms Log

System Overrides

Point Override Screen Functionality

Navigating and understanding the point override interface.

Binary Overrides

How to perform binary overrides on the TD7 display.

Analog Overrides

How to perform analog overrides on the TD7 display.

Setting Up Temporary Overrides

Data Graphing

Creating Custom Data Graphs

System Settings and Configuration

Control Settings: Schedules

User Login and Log Out

Schedule Creation and Defaults

Troubleshooting and Firmware Updates

Identifying and Diagnosing Issues

Table of common problems, causes, and solutions.

Upgrading TD7 Display Firmware

Step-by-step process for updating the TD7 firmware.