Trane Thermafit TACW - Settings Menu - Chiller and Compressor Configuration

30
ARTC-SVX007A-EN
Setting Menu The following tables shows the standard set of Setting
Menu screens.
Table 9. HMI settings menu screens
Screen User Interface Function Access
Chiller Control
• Admin Level Chiller SP Control
(see “Special Functions,” p. 32).
• Display and adjust chiller PID
settings (see section 3.8
Compressor Control of the Chiller
Control manual).
• Compressor staging control (see
“Special Functions,” p. 32).
• Evaporator / Condenser DP / flow
settings (if applicable).
• Tonnage calculation configuration
(see “Special Functions,” p. 32).
Main Menu > Settings Menu >
Control
Compressor
Setup
• Display and adjust compressor
specific parameters (see section
3.8 Compressor Control of the
Chiller Control manual).
• See T3C Documentation for
specifics on the settings with the
exceptions:
Main Menu > Settings Menu > DTC
Safety
Display and adjust safety parameters.
Note: The compressors have their own
safety settings for fault and
alarm. System should be
configured such that the
compressor settings have
priority.
Main Menu > Settings Menu > Safety
HMI
Configuration
Enable/Disable or select Special and
Optional Functionalities. Details for
each function are described in the
sections Special Functions and
Optional Functionalities.
Main Menu > Settings Menu > HMI
Admin access only.
Operating Procedures