Trane TR1 6002 - Page 103

103
0.. Operation and Display
# Parameter Factory Setting Range Changes 4-Setup Conversion Data
Description During Operation Index Type
001 Language ENGLISH Yes No 0 5
002 Active Setup SETUP 1 Yes No 0 5
003 Copying of Setups NO COPY No No 0 5
004 LCP Copy NO COPY No No 0 5
005 Max Value of User -defined Readout 100.000 0 - 999.999,999 Yes Yes -2 4
006 Unit for User-defined Readout %YesYes05
007 Big Display Readout FREQUENCY, % Yes Yes 0 5
008 Small Display Readout 1.1 REFERENCE, % Yes Yes 0 5
009 Small Display Readout 1.2 MOTOR CURRENT, A Yes Yes 0 5
010 Small Display Readout 1.3 POWER, HP Yes Yes 0 5
011 Unit of Local Reference % OF F MAX Yes Yes 0 5
012 Hand Start on LCP ENABLE Yes Yes 0 5
013 OFF/STOP on LCP ENABLE Yes Yes 0 5
014 Auto Start on LCP ENABLE Yes Yes 0 5
015 Reset on LCP ENABLE Yes Yes 0 5
016 Lock for Data Change NOT LOCKED Yes Yes 0 5
017 Operating State at Power-up AUTO RESTART Yes Yes 0 5
Factory Settings (continued)
Changes During Operation:
Yes means that the parameter can be changed while the drive is in
operation. No means that the drive must be stopped before a change
can be made.
4-Setup:
Yes means that the parameter can be programmed individually in
each of the four setups. The same parameter can have four different
data values. No means that the data value will be the same in all four
setups.
Conversion Index:
This number refers to a conversion figure to be used when writing or
reading to or from the drive by means of serial communication.
Since a parameter value can only be transferred as a whole number, a
conversion factor must be used to transfer decimals.
Example:
Parameter 201: Minimum Frequency, conversion factor 0.1. If
parameter 201 is to be set to 10 Hz, a value of 100 must be
transferred, since a conversion factor of 0.1 means that the transferred
value will be multiplied by 0.1. A value of 100 will, therefore, be
understood as 10.0.
Data type:
Data type shows the type and length of the packet.
Conversion Index Conversion Factor
74 3.6
2 100.0
1 10.0
0 1.0
-1 0.1
-2 0.01
-3 0.001
-4 0.0001
Data type Description
3 Integer 16
4 Integer 32
5 Unsigned 8
6 Unsigned 16
7 Unsigned 32
9 Text string
Conversion Index Factors
Data Type Descriptions