Trane Tracer UC210 User Manual

SAFETY WARNING
Only qualified personnel should install and service the equipment. The installation, starting up, and servicing of heating, ventilating, and air-
conditioning equipment can be hazardous and requires specific knowledge and training. Improperly installed, adjusted or altered equipment 
by an unqualified person could result in death or serious injury. When working on the equipment, observe all precautions in the literature and
on the tags, stickers, and labels that are attached to the equipment.
Tr a c e r
®
UC210 Programmable Variable-Air-Volume
(VAV) Box
Controller
Installation, Operation,
and Programming
BAS-SVX62E-EN
March 2016

Trane Tracer UC210 Specifications

General

Model	Tracer UC210
Controller Type	Unitary Controller
Input Voltage	24 VAC
Communication Protocol	BACnet MS/TP
Display	LCD
Inputs	Universal (Analog/Digital)
Outputs	Universal (Analog/Digital)
Operating Temperature	-4 to 131°F (-20 to 55°C)
Humidity Range	10% to 90% RH (non-condensing)

Summary

Introduction

Warnings, Cautions, and Notices

General safety advisories and definitions including warnings, cautions, and notices.

Copyright

Document ownership and usage rights.

Trademarks

Intellectual property notices for referenced trademarks.

Agency Listings and Compliance

Information regarding regulatory compliance and agency approvals.

Revision History

Document version control and changes made in revisions.

Overview

UC210 Features

Key functionalities and capabilities of the UC210 controller.

Controller Specifications and Dimensions

Physical and operational parameters of the controller.

Device Inputs/Outputs

Detailed list of controller input and output points.

The BACnet Protocol

Explanation of the BACnet communication standard.

Wiring Installation

UC210 Controller Pre-power Check-out

Essential pre-installation verification steps before applying power.

UC210 Controller Power Wiring

Guidelines for supplying electrical power to the controller.

BACnet MS/TP Communication Link

Setting up and configuring the BACnet MS/TP communication link.

Zone Sensor Wiring

Specific wiring instructions for zone sensors.

Controller LEDs

LED Activities and Troubleshooting Tips

Understanding controller status indicators and troubleshooting.

Tracer UC210 Controller Points and Parameters

Status Utility

Viewing real-time controller operational status and points.

Setpoints Screen

Configuring temperature and airflow setpoints.

Commissioning Screen

Procedures for unit calibration and setup.

Calibration, Operation Modes, and Control

Occupancy Modes

Description of controller operating states.

Space Temperature Control (STC) for Single Duct and Fan-powered Units

STC control algorithm details for VAV units.

Ventilation Flow Control (VFC)

VFC control algorithm details for VAV units.

Troubleshooting

UC210 Controller Failure

Steps to resolve controller failures.

UC210 Controller Communication Loss

Troubleshooting network communication issues.

Airflow Sensor Failure

Diagnosing and resolving airflow sensor problems.

Appendix: Typical Trane Factory Wiring Diagrams

Additional Resources