CG-SVU01B-E4 9
Starting/stopping the unit
Once the unit is powered on (main
disconnect switch closed) TRACER
CH532 returns to the following
display:
Line 2 gives current date and time
Line 3 gives current leaving water
temperature
Line 4 gives the unit status:
OFF BY KEYB = Local stop
UNIT ON = Unit running
Pressing from any screen will
return to this screen.
1. Starting the unit:
1. Press
2.Following screen will be displayed:
3.Press
4.Press or to change from
“N” to “Y”
5.Press . Following screen will
be displayed:
2.Stopping the unit
1. Press to exit from any menu
and return to default display.
2.Press for 3 seconds unit will
stop, and following screen will be
displayed:
3. Press to return to default
display
Note: In case of power failure unit
will restart in the state (operating
mode, setpoints…) it was in before
the power failure and default screen
will be displayed.
TRACER CH532 V2.0
01/05/04 00:00
Water Temp 20.0°C
OFF BY KEYB.
Status Unit
OFF BY KEYB.
Switch on unit ? N
TRACER CH532 V2.0
01/05/04 00:00
Water Temp 20.0°C
UNIT ON
Unit Switched Off
To Next Page
Loading...
Need help?
General
