Chapter 3 Configuring the Tracer MP580/581
30 CNT-SVP01C-EN
Figure 23. Device configuration AOs tab
3. In the Name list, click the output you want to configure. The configu-
ration information for that output appears in the tab.
You can also select the output by clicking the output number in the
AO list. The Name and AO lists are linked so that output name and
output number are always displayed together.
4. If you want to change the output name, highlight the text and type a
new name.
Use a descriptive name because it appears in custom displays and
programs.
5. In the Type list, click the analog output type. This selection sets the
default values under Calibration.
6. In the Units list, click the appropriate units.
7. In the Decimal Places list, click the number of digits you want to
appear to the right of the decimal.
You determine how many digits appear to the right of the decimal in
the Rover Active Device View and on the Tracer MP580/581 operator
display.
8. If the output requires calibration, type the amount by which you want
to adjust the value of the output in the Calibration Factor field.
To Next Page
Loading...
Need help?
General
