EasyManua.ls Logo

Trane WSC036A - Specific Safety Warnings and Notices; Refrigerant, Electrical, and UV Light Hazards; Roof Damage and General Notices

Trane WSC036A
64 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
RT-SVX23D-EN 3
Warnings, Cautions and Notices
When ordering replacement parts or requesting service, be sure to refer to the specific model
number and serial number printed on the unit nameplate.
WARNING
Contains Refrigerant under Pressure!
System contains oil and refrigerant under high pressure. Recover refrigerant to relieve pressure
before opening the system. See unit nameplate for refrigerant type. Do not use non-approved
refrigerants, refrigerant substitutes, or refrigerant additives.
Failure to follow proper procedures or the use of non-approved refrigerants, refrigerant
substitutes, or refrigerant additives could result in death or serious injury or equipment damage.
WARNING
R-410A Refrigerant under Higher Pressure than R-22!
The units (WSC036E-WSC060E) described in this manual use R-410A refrigerant which operates
at higher pressures than R-22 refrigerant. Use ONLY R-410A rated service equipment or
components with this unit. For specific handling concerns with R-410A, please contact your
local Trane representative.
Failure to use R-410A rated service equipment or components could result in equipment
exploding under R-410A high pressures which could result in death, serious injury, or equipment
damage.
WARNING
Hazardous Voltage w/Capacitors!
Disconnect all electric power, including remote disconnects and discharge all motor start/run
capacitors before servicing. Follow proper lockout/tagout procedures to ensure the power
cannot be inadvertently energized. Verify with an appropriate voltmeter that all capacitors have
discharged. Failure to disconnect power and discharge capacitors before servicing could result in
death or serious injury.
WARNING
Harmful Ultraviolet (UV) Lights!
Do not field install ultraviolet lights in the manufacturer air handling equipment for the intended
purpose of improving indoor air quality. High intensity C-band ultraviolet light is known to
severely damage polymer (plastic) materials and poses a personal safety risk to anyone exposed
to the light without proper personal protective equipment (can cause damage to eyes and skin).
Polymer materials commonly found in HVAC equipment that may be susceptible include
insulation on electrical wiring, fan belts, thermal insulation, various fasteners and bushings.
Degradation of these materials could result in serious damage to the equipment. Failure to
follow this recommendation could result in death or serious injury and equipment damage.
The manufacturer accepts no responsibility for the performance or operation of our air handling
equipment in which ultraviolet devices were installed outside of the manufacturer’s factory.
NOTICE
Roof Damage!
System contains oil and refrigerant under high pressure. Roofs should be protected from
exposure to oils and refrigerant in the system. If rooftop is not protected damage to the roof may
occur.

Table of Contents

Related product manuals