Neptune 4500 Page 5-3
5.2.2 LF (Line Feeds) Number Entry (A9)
1. While in the User Menu mode, scroll to "A 9", then scroll down once using the
UNIT/SET key to enter the Line Feeds menu.
2. The display will momentarily show "LF", followed by the current line feeds value.
3. Use the directional keys (shown in Figure 5-1 above) to adjust the displayed value
to the actual line feeds value. Increase the flashing digit by pressing the UNITS key.
Pressing the ZERO key will change the position of the flashing digit.
4. After setting the exact value, hold the UNIT/SET key to save the line feeds value.
The display will show "END" momentarily, then revert back up to A9.
To Next Page
