17
CODE/NAME DESCRIPTION SELECTION LIST
A9/C9
Line Feeds
Allows you to key-in the number of line feeds. Pressing the ZERO
key to scroll down one level begins the sequence.
Key-in
0 to 99
8√
√√
√
A10
Auto Power Off
- RF Digital
Indicator
Allows you to configure the automatic power off time for the RF digital
indicator. Expressed in minutes of inactivity (keys and weighing plat-
form). Pressing the ZERO key to scroll down one level begins the
sequence.
Key-in
0 to 30
5√
√√
√
A11
Hold Mode
This mode of operation is enabled by setting F30 to “5”. This mode
captures the weight of an unstable load, e.g. livestock, by freezing
the weight on the display. Use the Motion Band setting (F5) and the
Percentage Hold setting (F12) to adjust this mode to your specific
application. When the weight has been locked onto the display, two
arrows beneath the weight display will be turned ON.
"0" = Off
AUTOMATIC (A11 = 1) – Automatically locks weight on the display
when stable. If the weight of the object on the scale changes by the
F12 setting (e.g. 10%) then the sale unlocks the held reading and
relocks onto the new weight. This occurs during both increasing and
decreasing weight values.
MANUAL (A11 = 2) – Press the NET/GROSS key before applying
any weight to the scale. After the load has stabilized, the display will
hold the weight reading on the screen until the NET/GROSS key is
pressed again. If the weight of the object on the scale changes by the
F12 setting (e.g. 10%) then the sale unlocks the held reading and
relocks onto the new weight. This occurs during increasing weight
values only.
PEAK HOLD (A11 = 3) – The display updates as the load increases
but not as the load decreases. The value shown on the screen is the
maximum weight applied to the scale. Press the UNITS key to toggle
between live mode and peak hold mode. The ‘P’ annunciator is used
to indicate that you are in Peak Hold mode. When you exit out of
peak hold mode, the old peak value is automatically cleared.
0√
√√
√
1
2
3
A12
Backlight
Brightness
Selects the brightness of the LCD backlight. Selections are in % of
full brightness.
0 (OFF)
20
50
75
100√
√√
√
A13/C13
Handshaking
Selects function of the hardware handshaking. (NOTE: Receive pin is
used for handshaking).
"0" = Disabled
"1" = Enabled
0√
√√
√
1
A18
Date
Selects function of the printed date.
"no" = Disabled
"YES" = Enabled
no√
√√
√
YES
A19
Date Format
Selects the printed format for date.
"USA" = mm/dd/yy "IntL" = dd/mm/yy
USA√
√√
√ IntL
To Next Page
Loading...
Need help?
General
