2
INSTALLATION
PREPARATION
Any precision instrument requires a suitable environment in which to operate as intended. Please review
each of
the following
prior to installation:
Electrical Power
The
TI
-500
indic
ators have been designed to operate from 4-
AA alkaline
/rechargeable
batteries
and
ships with an AC adapter designed to operate from the local line voltage.
The un
it ship
s
with the
appropriate power plug for its area of intended use.
To avoid electrical
noise interference
and/or stray AC electrical transients
, try to operate the indicator
from a circuit
separate
from any equipment containing
inductive devices such as a contactor coil,
solenoid, relay coil, or motor
.
Be sure to
use shielded cables for the
load cell connections (ground shield
wire at indicator) and run these cables away from
your
AC/DC power cables
if possible
.
In extreme cases, it may be necessary to
install
surge suppressors, line conditioners or even UPS
(
Uninterruptible Power Supplies
)
systems
(not included)
.
Environment
-
Avoid installing the
indicator
in areas of direct sunlight
or
high humidity
-
Avoid sudden temperature change
–
if this is unavoidable allow equipment to ‘soak’ at a constant
temperature for at least three hours before
use
-
Ensure that steady, clean AC power
is available to the unit
Remember that the installer is ultimately responsible to assure that a particular
installation will be and remain safe and operable under the specific conditions
encountered.
CONNECTI
ONS
Fo
r the
TI
-500
model, the rear panel contains all connectors necessary to make the appropriate
connections to the weigh platform, printer, remote display and power supply.
To Next Page
Loading...
Need help?
General
