13
CPSMC19xx-100 PointSystem™ Chassis
slide-in-modules
24-hour Technical Support: 1-800-260-1312 -- International: 00-1-952-941-7600
2.3 Optional LED Slide-in-Module
The optional LED slide-in-module (CPSLD-100) allows the network administrator to
determine at a glance which power supplies are installed and in use.
The LED module can be installed in any slot in the front of the chassis. The proce-
dure to install and replace it is the same as any other slide-in-module. (See sec-
tions 2.1.3 Installing the Media Converter Slide-in-Modules and section 2.1.4
Replacing the Media Converter Slide-in-Modules for more information.)
When the chassis is powered on, the installed LED slide-in-module goes through a
self-test where the four LEDs will light up in sequence. After the self-test, the LEDs
indicate the current power supply operating conditions.
Power and In Use LED indicators are provided for
each installed power supply Modules (see the figure to
the right).
The numerical designation on the LED slide-in-mod-
ules is as follows:
1 Refers to the power supply installed in the left
installation slot (when looking at the chassis from
the rear).
2 Refers to the power supply installed in the right
installation slot (when looking at the chassis from
the rear).
See chapter 3 Powering the CPSMC19xx-100 for more information on the power
supply for the CPSMC19xx-100 chassis.
To Next Page
Loading...