8
CPSMC19xx-100 PointSystem
™
Chassis
slide-in-modules
2.1.3 Installing the Media Converter Slide-in-Modules
CAUTION: Wear a grounding device and observe electrostatic discharge precau-
tions when installing the media converter slide-in-module(s) into the chassis.
Failure to observe this caution could result in damage to, and subsequent failure of,
the media converter slide-in-module(s).
NOTE: The media converter slide-in-modules can be installed in any installation
slot, in any order.
To install the media converter slide-in-module into the CPSMC19xx-100 chassis:
1. If a chassis face plate is covering the installation slot, remove the face plate from
the installation slot by removing the one (1) screw that secures the plate to the
front of the chassis.
NOTE: If the slide-in-module requires two slots, remove the face plates from
two (2) adjacent installation slots.
2. Align the slide-in-module with the chassis installation slot so that the panel fas-
tener screw is at the top of the module.
3. Carefully slide the slide-in-module into the installation slot, while aligning the
module’s circuit board with the installation guides.
NOTE: Ensure that the slide-in-module is firmly seated inside the chassis.
4. Push in and rotate the attached panel fastener screw clockwise to secure the
module to the chassis.
5. Repeat steps 1 through 4 for any additional media converter slide-in-module(s).
24-hour Technical Support: 1-800-260-1312 -- International: 00-1-952-941-7600
To Next Page
Loading...