20
CPSMC19xx-100 PointSystem
™
Chassis
power supply
WARNING: Do NOT connect the power supply module to the external power before installing it into
the chassis. Failure to observe this caution could result in equipment damage and/or personal injury or
death.
3.4.2 Installing the Power Supply Module
The AC and DC modules are installed in the same manner.
NOTE: At least one power supply module must be set to ‘Primary.’ If both mod-
ules are set to ‘Secondary,’ neither will supply power to the chassis.
1. Remove the power supply module protective plate from the installation slot by
removing and retaining the two (2) screws that secure the plate to the chassis.
2. Set the Primary/Secondary switch and the Management/Manual switch, if nec-
essary. (See section 3.4.1)
3. Carefully slide the power supply module into the installation slot, aligning the
power supply module with the installation guides. Ensure that the power sup-
ply module is firmly seated inside the chassis.
4. Carefully install the two (2) screws (retained in Step 1) through the power sup-
ply module into the chassis, rotating clockwise to secure.
5. Connect the power supply module to the external power supply (AC: see page
15; DC: see page 17).
24-hour Technical Support: 1-800-260-1312 -- International: 00-1-952-941-7600
To Next Page
Loading...