Transition Networks PointSystem CPSMC1900-100 - Cascading Multiple CPSMC19 xx-100 Chassis; Cascade Cable Connection

To Next Page

To Previous Page

CPSMC19xx-100 PointSystem

™

Chassis

chassis

Cascading multiple CPSMC19xx-100 chassis

To cascade two or more CPSMC19xx-100 chassis:

1. Locate one (1) Transition Networks management module cascade cable (with

RJ-45 connectors installed at both ends) (P/N 6026) for each set of two (2)

chassis to be cascaded.

NOTE: Transition Networks management module cascade cables are one (1)

meter long. Ensure that the chassis are installed within one (1) meter of each

other.

2. At the first chassis in the series: Plug the RJ-45 connector at one end of the cas-

cade cable into the management module’s RJ-45 port labeled “OUT”.

3. At the next chassis in the series: Plug the RJ-45 connector at the other end of the

cascade cable into the management module’s RJ-45 port labeled “IN”.

4. At the same chassis as in step 3: Plug the RJ-45 connector at one end of the cas-

cade cable into the management module’s RJ-45 port labeled “OUT”.

5. At the next chassis in the series: Plug the RJ-45 connector at the other end of the

cascade cable into the management module’s RJ-45 port labeled “IN”.

6. Repeat steps 4 and 5 until all chassis have been connected.

24-hour Technical Support: 1-800-260-1312 -- International: 00-1-952-941-7600