17
16
A: Delete one record
DATA MANAGEMENT
Recall the Records
1.
When the monitor is off, please press MEM button to confirm the User,
then press START/STOP button to show the latest record .
Press the MEM button again to show the average value of the latest
three records.
If the records are less than 3 groups, it will display the
latest record instead.
2
. Press the MEM button or SET button to get the record you want.
The current No. is No 3. The corresponding
time is A.M. 7:08.
The corresponding
date is January 1st.
The date and time
of the record
will be shown
alternately.
If you did not get the correct measurement, you can delete the
result for the selected user by following steps below .
Delete the Records
1.Hold pressing MEM button
for 3 second when the monitor is
in the memory recall mode
(except average),the flash
display “dEL yES” will show
to delete the one group result.
2. Press MEM button or SET
button the flash displays “dEL no”
or “dEL yES”.
3. Press START/STOP button to
confirm deleting this group result
when it shows “dEL yES” and display
“User + donE”,then display the latest
record.
Tips: Press START/STOP button when it
shows “dEL no” , it will drop out.
DATA MANAGEMENT
To Next Page
Loading...
Need help?
General
