treesse Phantom PR1 - Minipool Functions

25
EN
5
2
4
6
3
4
1
7
U
minipool Phantom SP1
1 - Control panel
2 - Overow edge
3 - Pillow
4 - Whirlpool GHOST (optional)
5 - Whirlpool PLUS
6 - Filling / draining plate
7 - Filter / air regulator compartment
2
MINIPOOL FUNCTIONS
The minipool must ALWAYS remain connected to both the electrical grid and plumbing (lling and draining): this is
necessary for ltering, cleaning the lters and maintaining the minipool's water levels and temperature.
ALWAYS cover the minipool when inactive. This protects it from the sun's rays, prevents dirt from accumulating
inside the bathtub and keeps it from losing heat, thus optimising the efciency of the heater.
FILLING THE MINIPOOL
Filling is carried out by following the gures on the side
(follow the instructions for your keypad).
This occurs through a concealed spout in the compart-
ment on the bottom of the minipool and is indicated by
the illuminated red LED.
Filling takes place from the bottom of the bathtub, and
once it has nished the tank is lled.
After reaching the correct level, the system automati-
cally stops the lling and makes available the functions
of whirlpool, recirculation, ozone and heater.
During use of the minipool, the system automatically
maintains the water level ush with the skimmer edge
of the pool.
Automatic lling using the keypad: pressing the key activates the
automatic lling of the minipool, controlled by two level sensors and
conrmed by the xed blue key.
Use