treesse Phantom PR1 - Troubleshooting; Common Minipool Problems

49
EN
PROBLEM POSSIBLE CAUSE SOLUTION
Cloudy water, not very clear or dust
in suspension
• Water with unbalanced values
(hardness, pH, alkalinity).
• Incorrect or infrequent water treat-
ment.
• Excessive dirt brought in by users.
• Weather (if installed outdoors).
• Refer to the chapters:
1
page37
2
page41
3
page45
• Take a shower before entering the
minipool to remove residues of
cosmetics or lotions.
• Cover the minipool when not in
use.
Foam on the surface of the minipool
• Residues from sunscreens, cosmet-
ics, soaps.
• Water with unbalanced values
(hardness, pH, alkalinity).
• Overly soft water (lower hardness
to 7°f).
• Take a shower before entering the
minipool to remove residues of
cosmetics or lotions.
• Refer to the chapters:
1
page37
2
page41
Slippery bottom and walls, the pres-
ence of algae, greenish colour
• Water with unbalanced values
(hardness, pH, alkalinity).
• Incorrect or infrequent water treat-
ment
Refer to the chapters:
1
page37
2
page41
Bad odour or mould
• Water with unbalanced values
(hardness, pH, alkalinity).
• Incorrect or infrequent water treat-
ment.
• Water changed too infrequently.
• Canvas cover not cleaned well.
• Refer to the chapters:
1
page37
2
page41
• For the cleaning of the canvas
cover, see page47
Below are some problems you may encounter while using the minipool.
If the solutions offered do not solve the problem contact your dealer or the minipool manufacturer for suggestions.
Maintenance
minipool Phantom
T