treesse Phantom PR1 - Filling the Minipool

35
EN
minipool Phantom SP1
U
Maintenance
6B
FILLING THE MINIPOOL
Perform a preliminary cleaning of the minipool using a
bit of water and a mild detergent.
Do not use cloths or cleaners that are abrasive, aggressive
or that contain solvents because they could irreparably
damage the surface of the minipool.
Do not start any operation until the minipool has
been completely lled, otherwise the minipool
could be damaged.
Before lling, once again check the quality of the water
supply. This is very important for the well-being of the
users and for the long life of the minipool.
AUTOMATIC FILLING USING THE KEYPAD
Once the pool is powered, the display will show the word
"FxxRxx" and after a few seconds the display will show
the current ambient temperature.
Filling is carried out by following the gures on the side
(follow the instructions for your keypad).
Filling takes place from the bottom of the bathtub, and
once it has nished the tank is lled.
After reaching the correct level, the system automati-
cally stops the lling and makes available the functions
of whirlpool, recirculation, ozone and heater.
At this stage and until lling is completed, no other
functions of the minipool - except chromatherapy - will
be available.
During the lling phase, if the times for reaching the
minimum (90 min) and maximum (60 min) levels in the
overow tank are not met, alarms "AL1" (minimum level)
and "AL2 "(maximum level) will be triggered, stopping
all operation. In this case, you will have to disconnect
the power and restore it after about 30 seconds using
the product's main power switch and check the reason
for this anomaly (leaky pipes, obstructed supply valves,
insufcient pressure).
During the use of the minipool the system automati-
cally maintains the water level ush with the edge of
the bathtub.
Automatic lling using the keypad: pressing the key activates the
automatic lling of the minipool, controlled by two level sensors and
conrmed by the xed blue key.