30
EN
minipool Phantom SP1
OPERATIONAL FUNCTIONS
WATER
TEMPERATURE
SETTING
When turned on, the last temperature set by the user is loaded,
which can be displayed by pressing the “+” or “-” key.
To change it, press the “+” or “-” keys: this will increase/
decrease the displayed temperature by +/- 0.5°C.
After three seconds of inactivity, the display will return to
standby and the new temperature will be entered.
WHIRLPOOL
The
whirlpool
is started by:
press the key
whirlpool in progress is indicated by the xed blue key
The function can only be activated when the water is at op-
erational level.
When EMPTYING, the whirlpool is deactivated.
If not interrupted from the keypad, the function will be deac-
tivated automatically after 20 minutes.
CHROMATHER-
APY
OPTIONAL
OPTIONAL
* Colour sequence: White, Red,
Orange, Yellow 1, Yellow 2, Yellow
3, Green 1, Green 2, Green 3, Blue
1, Blue 2, Blue 3, Blue 1, Blue 2,
Blue 3, Purple.... White, Red, etc.
Chromatherapy
is started by:
pressing the
“Light” key
Activates a sequence of 16 colours that vary in an automatic
sequence.*
During the sequence, pressing the "Light" key again stops
on the current colour (e.g., Red): the sequence is interrupted
and remains xed on the chosen colour.
If you want to change this colour, by repeatedly pressing the
"Light" key you can run through all the colours to choose a
different one.
Once you have selected a xed colour, to return to the auto-
matic sequence you must turn off and reactivate the function.
Hold the "Light" key for two seconds to turn off the function.
If not switched off manually, the function stops automatically
after three hours.
The function can always be activated, even if the water level
is low.
Use
To Next Page
Loading...
