38
EN
Water treatment
TABLE OF ACTIVITIES
Below is a table that summarises all the activities necessary for proper maintenance. Those in blue should be car-
ried out frequently.
ACTIVITY
INFORMA-
TION
FREQUENCY...
CHECK PH VALUES,
HARDNESS AND
ALKALINITY
1
page37
Why check: Minipool water that is always clean and clear, but above all
bacteriologically pure and free of algae, guarantees safety and comfort
for users and offers the pleasure of a safe, relaxing bath.
How often: the minipool water (both its basic parameters and the
concentration of disinfectants and additives) should be checked 1 -
2 times a week under normal conditions of use (e.g., family use) or
daily if the minipool is used intensively (e.g., wellness centres) or if
it is installed outdoors. In this latter case, check the water especially
after intense rain.
Which products to use: reactive strips or tablets, liquid reagents
or instruments for measuring the parameters are readily available in
specialised shops.
For a disinfectant, the Manufacturer recommends its products (bromine
- 20 g slow-release tablets - combined with the use of ZERO PROBLEM
antialgae and OXIGEN ATTIVO GR granular oxygen).
If algae has already developed in the bathtub, the problem should
be solved as soon as possible, emptying the minipool, brushing the
walls and bottom of the spa thoroughly and performing a shock treat-
ment with liquid oxygen (OXI BLU).
DISINFECTION AND
CLEANING OF THE WATER
(FROM POLLUTANTS AND
ALGAE)
2
page41
CLEANING/REPLACING THE
PAPER FILTER
3
page45
Why check: the paper lter is a cylinder-shaped cartridge, mainly
consisting of cellulose and polyamide.
The water in the minipool enters the lter through a hole and comes
out from another, ltered and cleaned thanks to the cartridge within,
capable of retaining even very ne dust.
How often: Cleaning/replacing the paper lter depends on how often
the minipool is used. In general, rinse the cartridge every 2-3 weeks
and replace it with every change of water.
Which products to use: for cleaning just remove the cartridge from the
lter and wash it with a jet of clean water to remove hair and other for-
eign substances. For a deeper cleaning, leave the cartridge immersed
in a solution suitable for cleaning this type of lter, possibly overnight.
In any case refer to the instructions provided by the manufacturer of
the cleaning product used.
EMPTYING AND FILLING
THE MINIPOOL
4
page22
5
page23
How often and which products to use: the frequency of this opera-
tion depends on many factors, for example more or less intensive use,
outdoor or indoor installation, water quality, etc.
In general it is good practice to empty the pool every 30 days by
performing an energetic disinfection of the pipes, using the products
contained in the SPA CLEANING KIT.
CLEANING THE SURFACES
6
page47
How often and which products to use: cleaning the bathtub is an
important operation that should be carried out frequently (at least
twice a week), by brushing the walls and the bottom of the spa.
It is also essential to sterilize the pipes and the recirculation system,
an operation that can be easily carried out before emptying the pool
with the products contained in the SPA CLEANING KIT.
The manufacturer recommends the use of its products as they are
tested and compatible with the construction material. The use of
different products may cause damage to surfaces over time that is
not covered under warranty.
minipool Phantom
To Next Page
Loading...
