Trek Fetch+ 4 - Wheel and Tire Service

4-12
Resources Maintenance Riding Quick start Safety
4. Remove & replace your wheels
NOTE: With disc brakes, be careful not to press the brake lever after removing the wheel.
This may close the brake pads making it difcult for the rotor to go back inside the pads.
Rear Cargo Rear wheel
Remove Replace
NOTE: To make this easier, you may want
to use a bike stand or lay the bike on its
side.
1. Shift down to the smallest size gear.
2. Loosen and remove the thru axle
from the wheel.
3. Grab the derailleur body and push
down, then back, and release the
wheel from the dropouts.
4. Tilt the wheel and remove the chain
from the rear gears. Set the wheel
down with the gears up.
1. Standing at the rear of the bike, grab
the rear derailleur with your right
hand and pull back and push down
making sure the top of the chain
drops over the rst (or smallest) gear.
Make sure the wheel axle ts all the
way into the frame (dropouts) of the
bicycle.
2. Install and tighten the thru axle
making sure that the axle is properly
positioned within the dropouts.