4-14
Resources Maintenance Riding Quick start Safety
Replace
1. Reinstall the wheel back into the drop-
outs and tighten the hub nuts.
2. Rotate the wheel so the hub interface
is facing rearward.
3. Use the 2mm Allen wrench or nee-
dle-nose pliers to reinstall the upper
housing into the hub interface and
reconnect the upper cable stop to the
hub interface.
4. Reconnect the lower cable stop to the
hub interface and reinstall the lower
cable stop to the hub interface.
5. If you loosened the barrel adjusters
during removal, rotate them clockwise
to retighten.
6. Retighten the tension adjustment bolt
to remove slack from the belt.
To Next Page
Loading...
