TrekStor SURFBOOK E11B - Starting up the Surfbook for the First Time; Charging the Surfbook; Switching on the Surfbook

16
9. Starting up the Surfbook for the first time
First unpack your Surbook. Remove all components from the packaging and
completely remove the packaging material, including the protective ilm. Check
to ensure that the delivery is complete (see Section 6). If you ind that there are
missing or damaged components, contact customer service immediately.
Charging the Surfbook
Please fully charge your Surbook before you use it for the irst time.
Connect the DC plug of the included power supply to the socket (DC IN) of the
Surbook. Then plug the power supply into an electrical outlet.
i
ADVICE
Only leave the power adapter connected to the power socket until the Surfbook is
fully charged. Disconnect the power adapter from the socket first and then remove
the charging cable from your Surfbook.
i
ADVICE
The maximum battery life is reached after approximately charging cycles.
i
ADVICE
We recommend charging the Surfbook while it is switched off. This allows you
to get the maximum charging speed.
Switching on the Surfbook
Press the On/off switch for about 2-3 seconds to switch on the Surbook. The
charging LED lights up and the device starts up. A coniguration assistant
appears directly after the tablet has booted up. Follow the coniguration
assistant instructions to set up your Surbook.
i
ADVICE
During the setup process, the configuration assistant will prompt you to sign in
with your Microsoft account. If you do not yet have a Microsoft account, please
set one up at this point.