TREND LOCK/JIG - Default Chapter; Table of Contents; Technical Data

LOCK/JIG
-1-
Dear Customer
Thank you for purchasing this Trend product, we
hope you enjoy many years of creative and
productive use.
Please remember to return your guarantee card
within 28 days of purchase.
CONTENTS
TECHNICAL DATA _____________________1
SAFETY PRECAUTIONS ______________2-3
ITEMS ENCLOSED ____________________4
DESCRIPTION OF PARTS_______________5
ACCESSORIES _______________________6
- Assembly ___________________________7
- Setting the Spacers ___________________7
- Choice of Set-ups - Option 1 ____________8
- Option 2 ____________________________9
- Option 3 ____________________________9
- Fitting the Guide Bush ________________10
- Steel Templates _____________________11
- Template Selection Chart ______________11
- Special Note for Template 11 ___________11
OPERATION
- Marking Out ________________________12
- Centring the Jig______________________13
- Quick Centring for 44mm doors _________13
- Routing the Mortise___________________14
- Routing the Face-plate ________________14
- Finishing ___________________________15
- Deeper Mortise ______________________15
- Cutting Key & Spindle Hole ____________15
MAINTENANCE ______________________15
ENVIRONMENTAL PROTECTION________15
GUARANTEE ________________________15
SPARE PARTS
- Spare Parts List _____________________16
- Spare Parts Diagram__________________IB
☎
If you require further safety advice,
technical information or spare parts,
please call Trend Technical Support
or visit www.trend-uk.com
TECHNICAL DATA
Cutter size 12mm
Min. workpiece 34mm
Max. workpiece 58mm
Template size 59.8mm x 239mm
Largest face plate inner 32mm x 177mm
aperture size
Guide bush size 30mm
Weight 4.5kg
The following symbols are used throughout this
manual:
Denotes risk of personal injury, loss of
life or damage to the tool in case of non-
observance of the instructions in this
manual.
Refer to the instruction manual of
your power tool.
This unit must not be put into service until it has
been established that the power tool to be
connected to this unit is in compliance with
2006/42/EC (identified by the CE marking on the
power tool).
INTENDED USE
This jig is intended for use with a plunge router
with suitable guide bush and router cutter fitted
to rout a mortise and face plate for locks in
wooden doors.
MANU-LOCK v9.1_MANU-LOCK v9 20/06/2013 09:04 Page 1