LOCK/JIG
-6-
ACCESSORIES
Please use only Trend original accessories.
30mm Guide Bush
Ref. GB30
Universal Sub-base
Ref. UNIBASE
The Unibase contain screws, a line up bush and pin.
The line up pin and bush ensure exact alignment of
sub-base with the router spindle, when fitted with the
relevant collet.
Fits following router models
Atlas Copco OFSE2000 Bosch GOF 1300ACE, 1600A,
1700ACE Casals FT2000VCE CMT CMT1850, 2000,
DeWalt DW624, 625EK, 629 Draper R1900V Elu MOF 131,
177(E) Felisatti TP246(E), R346EC Festo OF2000E Freud
FT2000E Hitachi M12V, M12SA, TR12 Metabo OF1612,
OFE1812 Ryobi RE600N, R600N, RE601, R500, R502 Skil
1875U1 Wadkin R500
Door Stand
Ref. D/STAND/A
Holds door on it’s edge whilst routing hinge recess
and mortise for locks. Maximum weight 50kg and for
doors 32mm to 55mm thick. Allows door to be tilted
back to assist fitting to door frame.
Door Clamp
Ref. D/CLAMP/A
Holds door whilst drilling and fitting locks. Ratchet
clamp design for doors up to 55mm thick.
Corner Chisel
Ref. C/CHISEL
Squares up rounded corners in one operation. High
speed steel. Use with a hammer.
24” Carry Case
Ref. CASE/DH
Accepts Door Stand, Lock Jig, Door Clamp and
accessories.
Should the correct guide bush not be available
to suit your router’s base, you will need to use
the Trend UNIBASE in conjunction with a 30mm
guide bush, Ref. GB30 or 16mm guide bush
Ref. GB160.
MANU-LOCK v9.1_MANU-LOCK v9 20/06/2013 09:04 Page 6
To Next Page
Loading...
