Restart your router
Maintenance > Reboot Device
You may want to restart your router if you are encountering difficulties with your
router and have attempted all other troubleshooting.
There are two methods that can be used to restart your router.
Turn the router off disconnect the power adapter from the rear panel of your
router for 10 seconds and reconnect the power adapter, see “Product Hardware
Features” on page 2 .
Use this method if you are encountering difficulties with accessing your router
management page. This is also known as a hard reboot or power cycle.
OR
Router Management Page: This is also known as a soft reboot or restart.
1. Log into your router management page (see “Access your router management page”
on page 22).
2. Click on Maintenance, and click on Reboot Device. If prompted, click yes or OK.
3. Click Reboot to restart the router. If prompted, click yes or OK.
Check connectivity using the router management page
Maintenance > Ping
For troubleshooting purposes, you may want to check your router connectivity using
the ping (also known as a network connectivity test) test tool on your router
management page.
1. Log into your router management page (see “Access your router management page”
on page 22).
2. Click on Maintenance, and click on Ping.
3. Next to Host IPv4 Address, enter in the IP address (e.g. 192.168.10.101) or host
name (e.g. www.trendnet.com) to test and click Ping.
4. You will receive a success or fail result message of the address you entered providing
a basic indicating of the router’s connectivity to the Internet or devices that are
connected to your network.
Manage Initialization Scripts
Maintenance > Init Script
This page allows you to show, delete, and import initialization scripts running on
customer-premises equipment (CPE), such as telephones, routers, or set-top boxes,
during system startup or shutdown.
Init start scripts are scripts that run before the system starts up. Init end scripts are
scripts that run before the system shuts down.
1. Log into your router management page (see “Access your router management page”
on page 22).
2. Click on Maintenance, and click on Init script.
3. Click Browse and select your script.
4. Click Import Script to import script to router.
To Next Page
Loading...
Need help?
General
