SMTP Password/Confirm Password: Enter the password required for
authentication by your SMTP mail server. Enter the password again in the
Send router logs to your e-mail address
Maintenance > Syslog
1. Log into your router management page (see “Access your router management page”
on page 22).
2. Click on Maintenance, click on Syslog.
3. Review the e-mail log settings and click Apply to save setting.
SMTP Server: Check the box to enable the email log notification.
SMTP Server IP: Enter the IP address (i.e. 10.10.10.10) or domain name (i.e. mail.
trendnet.com) of your e-mail server.
Source E-mail Address: Enter the sender or source mail address. You can use this
to easily identify the notification in your email inbox. (i.e. modem_router@
trendnet. com)
Destination E-mail Address: Enter your e-mail address.
SMTP Authentication: Check the box if your e-mail server requires authentication.
SMTP Username: Enter the account name required for authentication by your
SMTP Password/Confirm Password: Enter the password required for
authentication by your SMTP mail server. Enter the password again in the
Time Frequence: Select the frequency of logging e-mails.
Enable SNMP on your router
Advanced > SNMP
SNMP (Simple Network Management Protocol) is a network management protocol
used to monitor (read) and/or manage (write) multiple network devices on a network.
This preconfigured external SNMP server.
1. Log into your router management page (see “Access your router management page”
on page 22).
2. Click on Advanced and click on SNMP.
3. Review the options for SNMP and click Apply to save settings..
System Contact: Enter the contact person or contact information for your modem
router.
System Name: Enter an assigned name for your modem router.
System Location: Enter an assigned location for your modem router.
Public Community/Private Community: Enter a public and private community
name.
Trap: Check this box to enable the Trap function, then provide the following
information:
Trap Version: Select an SNMP trap version.
Trap Address: Enter the destination IP address of the SNMP trap.
To Next Page
Loading...
Need help?
General
