4. On the Traffic Bandwidth Interval section, enter the interval of refreshing the traffic
bandwidth.
Configure your router log
Maintenance > Syslog
You may want send your router log to your e-mail address or to an external log server
(also known as Syslog server) so you can check it periodically while away from home.
You may also want to only see specific categories of logging.
Send router logs to an external log server
Maintenance > Syslog
1. Log into your router management page (see “Access your router management page”
on page 22).
2. Click on Maintenance, click on Syslog.
3. Next to Syslog and check Enable.
4. Click Add in Log Rules Settings. Click Apply to save settings.
Module: Select the module type.
Facility: Select the facility type.
Severity: Select the severity level.
Note: emerg is the highest level while debug is the lowest level.
Location: Enter an assigned location for your log.
Note: The succeeding fields may vary depending
If the Location is set to Mail, configure the following settings:
SMTP Server IP of Domain Name: Enter the IP address (i.e. 10.10.10.10) or
domain name (i.e. mail.trendnet.com) of your e-mail server.
Source E-mail Address: Enter the sender or source mail address. You can se this
to easily identify the notification in your email inbox. (i.e. modem_
router@trendnet. com)
Destination E-mail Address: Enter your e-mail address.
SMTP Authentication: Check the box if your e-mail server requires authentication.
If enabled, enter the account name and password in the
SMTP Username: Enter the account name required for authentication by your
SMTP mail server.
To Next Page
Loading...
Need help?
General
