12
Detail Programming Setup Values Continued
Dialer Modes: (Defaults to 1)
Command to set: 6n Where "n" is the method the unit employs for dialing functions.
Options are:
n=0 with call progress, false dial=off, verify dialtone=off
n=1 without call progress, false dial=off, verify dialtone=off
n=2 with call progress, false dial=on, verify dialtone=off
n=3 without call progress, false dial=on, verify dialtone=off
n=4 with call progress, false dial=off, verify dialtone=on
n=5 without call progress, false dial=off, verify dialtone=on
n=6 with call progress, false dial=on, verify dialtone=on
n=7 without call progress, false dial=on, verify dialtone=on
Call Progress must be allowed (with) if the unit is expected to respond to a Busy Signal,
Ring Signals or Voice detection for the purposes of redialing another number on Busy
detection or Voice Detection as required for the electronic doorman (TED) operation.
Without Call Progress being enabled, the unit reverts to a simple single number dialer and
TED will not function as desired.
False Dial On forces the unit to create the impression to the visitor that it has dialed a
number. It makes random Touch Tone sounds to the speaker as if speed dialing. This gives
the visitor a sense that the unit is working and pre-empts their inclination to pump the
dial button, as if that will speed the process up like is mistakenly believed with
elevators and traffic lights.
False Dial Off results in a voice that declares that the dialing process is in action by
playing system message #2 "Dialing in progress, please stand by" to the visitor. If
message #2 is diverted to another function or disabled, then it's a good idea to enable
false dialing.
Verify Dial Tone forces the unit to test the dial tone for an additional 3 seconds before
dialing proceeds. This is most useful when the unit shares the line with another unit. You
do not want to dial into another's conversation with touch tones that might possibly be
misinterpreted as permission to grant entry or a hang up command tone.
The unit always waits for some dial tone before dialing. This test just helps confirm that
the dial tone is real and not some other kind of tone or even voice on the line.
Note: In all cases, if a dial tone is not detected, then the unit will respond with a busy
indication to the visitor at the loud speaker.
Roll Over Limit: (Defaults to 6)
Command to set: 2*n Where "n" is the value of ring detects before redialing.
Like a busy signal, this unit can detect and count ring tones. If the roll over limit is
exceeded then it is assumed that no one is going to answer because of excessive ringing.
So the unit will roll over to the next number to dial, if more than one number exists.
Note: If this value is set to zero "0" then Call Progress is ignored and the unit becomes
a single number dialer and the TED option will not work properly.
Security Mode: (Defaults to 0)
Command to set: 6*n Where "n" is the security level.
Level 0: A single touch tone is all that's required to grant access to a visitor.
Level 1: A repeated touch tone is required to grant access to a visitor.
Level 2: A command tone followed by a valid entry code is required to grant access.
It is strongly suggested that Level-1 be employed whenever possible. Unlike the good old
days, many folks now carry personal tone generators in the form of Cell Phones. If an
access tone is injected into the conversation, the equipment may falsely grant access.
To Next Page
Loading...