26
Detail Programming Greeting Screens
If a Display is present and the Greeting Screens are enabled then the following applies.
The greeting screen or screens supply addtional information to a visitor beyond the basic
instruction screen, which is preset to factory defaulted text. You may supply extra
instructions, rental information or simple greetings to visitors.
Note: Macro Command 90 used in Event-1 will disable the normal instruction screen.
These screens can be disabled by clearing all displayable text. The time duration of the
screen is calculated as 2 seconds plus 1 second per displayable line, approximately.
From programming mode you may view these screens via command *#*.
Use the "*" command to view the 2nd screen if enabled.
To Edit Greeting Screen 1 using command #6:
#6 Edit Greeting screen 1.
To Edit Greeting Screen 2 using command #7:
#7 Edit Greeting screen 2.
To Exit this Text Editor simply hold down the Star Key "*" for about 3 seconds.
Refer to Page 9 on the subject of Basic Text Editing for additional details.
Detail Programming Prompt Lines
Assuming your unit supports a display and the Prompt Lines Option was enabled and Macro
Commands are also properly programmed, then the following applies.
Prompt lines are only usable via Macro Commands. These are commands that enable you to
send special prompts to your display at various points in a customized procedure. You can
setup a Macro Command to display a custom message when needed. For example, a resident can
send a defined tone that issues a special display prompt like: "Go to 2nd Elevator", to
reach their floor, etc.
Prompt lines are numbered 1 to 8 and where they appear on the display screen depends on
the number of lines your display supports.
8-line displays 4-line displays 2-line displays
Prompt line 1: -- Line 1 ---------- Line 1 ---------- Line 1
Prompt line 2: -- Line 2 ---------- Line 2 ---------- Line 2
Prompt line 3: -- Line 3 ---------- Line 3 ---------- Line 1
Prompt line 4: -- Line 4 ---------- Line 4 ---------- Line 2
Prompt line 5: -- Line 5 ---------- Line 1 ---------- Line 1
Prompt line 6: -- Line 6 ---------- Line 2 ---------- Line 2
Prompt line 7: -- Line 7 ---------- Line 3 ---------- Line 1
Prompt line 8: -- Line 8 ---------- Line 4 ---------- Line 2
To Edit Prompt Lines using command #8:
#8 Edit Prompt Lines. The display provides line numbering details.
To Exit this Prompt Editor simply hold down the Star Key "*" for about 3 seconds.
Refer to Page 9 on the subject of Basic Text Editing for further details.
Note: You should issue a Macro Command to clear the display before sending prompts.
Refer to Page 31 on the subject of Macro Commands for further details.
To Next Page
Loading...