3
Quick Residence Dialer
The programing of this product is a close match with former Trigon Residential Dialers.
You may program via the Keypad or Remote Touch Tone by calling the Unit.
Note: Remote Touch Tone Programming does not allow Edits of Text Data Fields.
To Access Programming Mode:
Push Call Button at the Unit's Front Panel. You should hear a false Dial Tone.
Or you may call the Unit and wait for the Unit's Answer Tones.
Enter the Programming Mode using key sequence: *2468. (former units used *5269)
You should hear two "ACK" tones and the panel display, if available, shows "Program Mode".
Creating a New Resident with a Phone Number Assignment:
Format: #0 123*5551212# (Beep-Beep)
Where:
#0 is the command to Create or Modify a Resident's data.
123 defines the Resident's Code. (This is the Code a Visitor dials to call a Resident)
The * key separates the Resident Code from their Home Phone Number.
5551212 is their specific Home Phone Number up to 16 digits.
The # key terminates this Command.
(Beep-Beep) means the Command was accepted or "Long-Tone" means Command was rejected.
Obviously, replace the 123 and the 5551212 above with the correct desired numbers.
New! Resident Codes may now be variable length of 1 to 4 digits mixed.
New! Multiple phone numbers may be allowed per Resident on special request.
Enter: #0 123*5551212# Assigns or replaces Resident 123’s 1st Phone Number.
Enter: #0 123*2*5551212# Assigns or replaces Resident 123’s 2nd Phone Number.
Enter: #0 123*3*5551212# Assigns or replaces Resident 123’s 3rd Phone Number.
Enter: #0 123*3*# Deletes Resident 123’s 3rd Phone Number.
Enter: #0 123# Deletes Resident 123 entirely from System.
Entry Codes assigned to Specific Residents:
New! Multiple Entry Codes and Card Codes are allowed per Resident on special request.
New! Entry Codes are now mixed variable length of 1 to 6 digits per.
Enter: #1 123**2468# Assigns Resident 123's 1st Blank Position with Entry Code of 2468.
Enter: #1 123*1*1357# Assigns Resident 123's 1st Entry Code as 1357.
Enter: #1 123*2*2468# Assigns Resident 123's 2nd Entry Code as 2468.
Enter: #2 123*1# Deletes Resident 123's 1st Entry Code.
Enter: #2 123# Deletes all of Resident 123's Entry Codes.
Card Codes assigned to Specific Residents:
Enter: #1 *123**13579# Assigns Resident 123's 1st Blank Position with Card Code of 13579.
Enter: #1 *123*1*13579# Assigns Resident 123's 1st Card Code as 13579.
Enter: #1 *123*2*24680# Assigns Resident 123's 2nd Card Code as 24680.
Enter: #1 *123**44444# Assigns Card Code of 44444 to 1st Blank Card Code position.
Enter: #2 *123*1# Deletes Resident 123's 1st Card Code.
Enter: #2 *123# Deletes all of Resident 123's Card Codes.
Enter: #9# Edit 1st Residents Name for Directory Display. (see page 9)
Enter: #9 123# Edit Resident 123's Name for Directory Display. (see page 9)
Enter: ## Exits Programming Mode.
Please do not presume 100% compatability with the original MiniGuard Command Set.
To Next Page
Loading...