4
Quick Single Button Dialer
The programing of this product is a close match with former Trigon Single Button Dialers.
You may program Unit via Remote Touch Tone by calling the unit or use the optional Keypad.
Access Programming Mode:
Call the Unit and wait for the Unit's Answer Tones or use the optional Keypad.
Enter Programming Mode using tone-key sequence: *2468. (former units used *9753)
You should hear two "ACK" tones and the panel display, if present, shows "Program Mode".
Program a Phone Number(s) to Dial:
Format: 2 1 5551212# (Beep-Beep)
2 is the Command to store a Phone Number.
1 is the Desired Position in a List, with 1 as the 1st position, 2 as the 2nd, etc.
5551212 is the Phone Number, up to 16 digits, dialed when the Call Button is pushed.
The # key terminates this Command.
(Beep-Beep) means the Command was accepted or "Long-Tone" means the Command was rejected.
Example: 2 1 5551212# Sets the 1st phone number to 5551212.
Example: 2 2 5551234# Sets the 2nd phone number to 5551234.
If you set the 1st phone number blank, as in "21#", the unit will be in Ring-Down Mode.
Enter: 2*6 Sets the ring roll over limit to 6 rings after dialout.
After dialing and detecting 6 rings the next number in your list is then tried.
At the end of the list you may restart the list from the top or just stop trying.
Use Command:
Enter: 4#0 Sets Unit to stop dialing at the end of the phone number list.
Enter: 4#2 Sets Unit to restart dialing again from the top of the phone number list.
Enter: 60 Enables Unit to detect Ring and Busy tones needed for list dialing.
Enter: 61 Disables tone detection, forcing the Unit to be a one number dialer.
Note: Adding 2 to the Commands just above (62 or 63) replaces a Voiced Announcement
with a False Dialing sound. This lets the Visitor know that a Call has been placed.
Enter: 71 Sets the Gate Open Time to 5 seconds (1 x 5-Seconds = 5 Seconds)
Enter: 73 Sets the Gate Open Time to 15 seconds (3 x 5-Seconds = 15 Seconds)
Enter: 70 Sets the Gate Open Time to just a quick Pulse for Sliding Gates.
Enter: 8 120 Sets the Call Length Limit to 120 seconds, before automatic hangup.
Enter: 8 060 Sets the Call Length Limit to 060 seconds, before automatic hangup.
Enter: 1 1234 This sets the Unit's Site ID to 1234. (default)
Enter: 3 2468 This sets the Unit's Program Access Code to 2468. (default)
Enter: ## This terminates the Program Session and Unit is ready to operate.
Please Note: This one page Guide is for those users of Trigon's HF2 line of products.
Shown here is the minimum amount of detail needed to make this unit work as desired.
This is, by no means, the limit on this Units abilities. Please read those sections
in this manual that fully explain the Options and Commands that are available or relevant
to your needs.
Please do not presume 100% compatability with the original HF2 Command Set.
To Next Page
Loading...