5
Basic Operation Guide
This unit has two basic modes of operation.
1. Residential Dialer. (MiniGuard-2 Series)
2. One Button Dialer. (HF-2 Series)
As a Residential Dialer: A keypad is supplied for the purposes of dialing a residence or
office inside a multi-number business or apartment complex.
Residential Dialer Procedure:
A Visitor arrives to face a locked entry gate. The visitor finds the desired party, via
some form of directory, that has the authority to grant them entry. Once they spot the
party they wish to visit on the directory, they should notice a short code number assigned
to that same party. They push the call button and dial the short code number. Hopefully,
their party will answer and identify the visitor by voice. The inside party then sends a
touch tone command to briefly unlock the entry gate and permit the visitor entry. The unit
then resets itself and is now ready for the next visitor.
If a Resident has several phone numbers and this unit allows several numbers per resident,
then you must enable Call Progress in the Dialer Modes to redial properly. Then the 1st
number is dialed, and if busy or extended ringing is detected, it proceeds to try the 2nd
number. If all attempts fail and you wish to loop back to the 1st number again, then
enable Dial Looping. The Call Limit Timer stops this from looping forever. Voice detection
is by non-symmetrical tones on the line which prevents redialing and enters answered mode.
Residents or office workers may gain entry access into their own building by using an
assigned entry code at the keypad. Residents may also have been given an electronic pass
card or Fob that can be used near an electronic reader to grant personal entry.
Programming of this unit may be done via the local Keypad, remotely via Touch Tones, via
56K Modem and via direct PC connection through Rs232 or Rs485. The PC must have TriComPro
software installed on it. Also, we have a Lan Module that can replace the 56K modem if a
Local Area Network connection is desired. A unit thus equipped can then also be programmed
via the internet, if supplied with a net connection with a static router IP address.
As a One Button Dialer: A call button is supplied for the purpose of dialing a specific
number into a business, emergency, or security center.
One Button Dialer Procedure:
A visitor arrives to face a locked entry gate. They push the call button and wait for a
response from inside. Hopefully, their call is answered and identification of the visitor
is done by voice. The inside party then sends a touch tone command to briefly unlock the
entry gate and permit the visitor entry. The unit then resets itself and is now ready for
the next visitor.
Employees or office workers may gain entry access into their own building by using an
assigned entry code at the optional keypad. Employees may also have been given an
electronic pass card or Fob that can be used near an electronic reader to automatically
register a special access control number to grant personal entry.
Programming of this unit may be done via the local Keypad, remotely via Touch Tones, via
56K Modem and via direct PC connection through Rs232 or Rs485. The PC must have TriComPro
software installed on it. Also, we have a Lan Module that can replace the 56K modem if a
Local Area Network connection is desired. A unit thus equipped can then also be programmed
via the internet, if supplied with a net connection with a static router IP address.
This new product release has the potential to be custom setup by the end user to operate
in either version modes. In fact, it can be one version by day and the other by night.
It's really that flexible.
To Next Page
Loading...