Trim Pot Variable Resistor
The trim pot provides adjustable settings for timed outputs. Clock-
wise rotation increases activation time.
Dome/porch light activation (5-60 second range).
Auxiliary 1 output (0.5-5.0 minute range).
Auxiliary 2 compartment lighting output (0.5-5.0 minute
range).
Note:
Trim pot setting is updated every 30 seconds.
Trim pot adjustment may not be observed immediately.
Status LED
LED flashes at power-up and can provide other troubleshooting
diagnostics codes.
e-ASK Doorbell Mode
The following procedure turns the keypad doorbell mode on or off.
The factory default is doorbell mode off.
1. Ground the yellow wire. The buzzer sounds for 3 seconds
and the keypad backlights will flash.
2. Press and hold the (5 / 6) (3) button for 5 seconds. The
keypad will chirp.
3. Press the (9 / 0) (doorbell) button to activate doorbell mode
or press the (1 / 2) (1) to deactivate doorbell mode.
4. A single chirp sounds followed by 1 beep for standard mode
activated and 2 beeps for doorbell mode activated.
5. If a TriMark vehicle I/O module is recognized on the CAN
network, it will be automatically updated to doorbell mode.
Miscellaneous I/O Module Features
Door Locking and Unlocking
A pulse output provides locking and unlocking operation to the entry
doors and the compartment doors (banks A-D). The locking and
unlocking pulses have opposite polarities. Locking and unlocking
operations are activated via e-PAD, e-FOB, and vehicle switch
inputs.
7
To Next Page
