6
Configuration D [SW 4 off / SW 5 on / SW 6 on]:
1) J1 pin 1: Unlock curb-side compartment doors (banks C-D)
2) J1 pin 2: Unlock driver-side compartment doors (banks A-B)
3) J1 pin 9: Unlock entry door(s)
4) J1 pin10: Unlock all doors
5) J1 pin 11: Lock all doors
6) J1 pin 12: Lock entry door(s)
Note: Configuration D is the default.
DIP Switch 7:
The setting of DIP switch 7 defines the type of remote FOB transmitter,
either standard FOB or cargo FOB.
Off: Standard FOB
On: Cargo FOB
DIP Switch 8:
The setting of DIP switch 8 defines the type of CAN protocol, either RV-
C or SAE J1939.
Off: RV-C
On: SAE J1939
Additional Features
Dome/Porch Light Activation
The dome/porch light is activated for a timed duration (5-60 seconds)
whenever a keypad button is pressed or when system is unlocked from
FOB transmitter or vehicle switch. The time duration is dependent on
the trim pot setting. The dome/porch light is deactivated with starting
the engine or locking the entry doors.
e-PAD Anti-tamper Deactivating Feature
After repeated attempts to enter correct code (20 button presses
without enabling), the keypad enters an inactive mode that disables
buttons for 1 minute. This helps prevent undesired access by entering
random codes. No beep will sound with button press while the system
is disabled.
e-Grab Handle Lighting
The grab handle is lit continuously. The e-PAD back lighting is lit with a
button press and while training new access and authority codes.
To Next Page
Loading...
