Page 10 of 16
TABLE
2: LOCK, UNLOCK, AND DOOR ACTUATE RELAY OUTPUT CONNECTIONS
With the exception of Zone 6 output, each of the above relay banks provide positive and
negative current flow for typical motorized actuators. The relay banks are rated for 25 amps
and thus the cumulative (sum of all actuators) current flow should be less than 25 amps.
Zone 1 is designated as an entry door output while the remaining banks are undesignated.
These can be use for secure access of occupant doors, specialized compartment, baggage
doors, or miscellaneous doors. See page 6 for further information on S2 DIP switch settings.
The Zone 6 output is unidirectional and is intended for an actuating operation, such as
opening the hood, gas cap door, or disconnecting the battery. Contact TriMark for further
technical assistance and to ensure that actuators and relay assignments are appropriate.
Correct installation will promote better reliability of the system.
J9 CONNECTOR: Unidirectional Actuation Output (E.G. Door Opening Or Battery
Disconnect
J10 CONNECTOR: Lock/Unlock Bank D
J8 CONNECTOR: Lock/Unlock Bank C
J7 CONNECTOR: Lock/Unlock Bank B
J5 CONNECTOR: Lock/Unlock Bank A
J6 CONNECTOR: Lock/Unlock Zone 1 (Entry)
To Next Page
Loading...
