User's Manual
750 50 0042 03 16
3.
Use the setting gauge supplied with the instrument to
carry out this operation.
Note:
A different setting gauge may be used. In this case,
its dimension must be configured in the set-up menu
(§ 13.2).
4. Move the measuring insert downwards (use the
handwheel for the displacement of the measuring
carriage) until it touches the surface and an acoustic
signal confirms the measurement (=probing).
5. Without moving any part (instrument and gauge),
move the measuring insert towards the top and
perform the same sequence on the upper surface of
the setting gauge.
6. Repeat the sequences 4 and 5 one more time. This
allows establishing the probe constant more
precisely.
2x
7.
The screen will display the setting gauge value during
the latest probing, as well as that of the new probe
constant. The instrument is then ready to be used.
In motorised mode, this procedure can be carried out
automatically by pressing one of the grey arrows on the
right of the screen.
The probe constant needs to be checked and stored again after each measuring
insert change, after change of its position in the holder, after each adjustment of
the measuring force or adjustment of the floating probe suspension.
To Next Page
Loading...
Need help?
General
