Do not remove the original package and keep the wrapping film and carton
box in a good condition, if the modules require long-distance transport or
long-term storage.
For long-term storage, it is recommended to store the modules in a
standard warehouse with regular inspection, and under confirming of your
personal safety, reinforce the package in a timely manner if any anomalies
are found.
The warehouse shelves should have sufficient carrying capacity and storage space, regular
inspection is required to ensure the storage safety.
If you need to store the modules in the project site, do not choose soft ground and the ground that
is easy to collapse, should choose a hard ground or a higher ground with flat surface to ensure the
module packages not collapsing and tilting for long-term storage.
In rainy weather, please fully cover the modules and pallets with a rain protection and take moisture-
proof measures on pallets and cartons to prevent collapse and moisture ingress. Under sun or wind,
remove the rain cloth to allow the package to dry as soon as possible, prevent package collapse
caused by the rain.
Do not allow the pallets to soak in water. The ground drainage measures should be done previously
for the storage site to prevent a large amount of water accumulation on the ground after rain, causing
the ground to soften, sink, etc.
Do not allow unauthorized persons to access the module storage area.
The modules should be centrally stored.
5 UNPACKING INTRODUCTION
5.1 UNPACKING SAFETY
Before unpacking, please check the product type, power bins, serial number and relevant
suggestions on the A4 paper of the packaging box, and read the unpacking instructions carefully.
Custom unpacking methods are prohibited.
Before unpacking, please make sure that the packaging box is in good condition, it is recommended
to use art knife to remove the packing belt and wrapping film. Violent removal is prohibited to avoid
scratching the modules in the box.
Please check that the number of modules in the box and the barcode information on the module
frame are consistent with the information on the A4 paper on the packaging box.
Please follow the recommended unpacking steps to unpack the modules. When unpacking, it must
be operated by two or more people at the same time. Always wear insulating gloves when handling
the modules.
To Next Page
Loading...
