3. Press
key. Immediately, ”P
”
starts blinking which shows that CT-Primary
can now be set. Set the desired CT-Primary by pressing
and
keys and
then press
to confirm the setting.
4.
Now,the unit will reset and return into Run mode
Setting CT Secondary:
The CT-Secondary can be set to either 5 or 1.
To set CT-Secondary, Proceed the following instruction:
1. In the Run Mode display,Press PROG/ENTR key for about 4 to 5 seconds.The
unit will prompt CT Primary and then,press "UP" key till you get display CT
Secondary with following display.
2.
Press PROG/ENTR key again, Immediately, P starts blinking which indicates
that the parameter can now be changed. Set the parameter value by pressing
"UP" and "DOWN" keys untill the desired value is received.
3.
Press PROG/ENTR key to confirm the parameter value. Hence, the unit will
restart and return into Run Mode
Setting Device Id
The unit also supports RS485 communication port and it should therefore be set the
Device ID from 1 to 255 for the communication of it.
To set Device ID, proceed the following instruction:
1.
In the Run Mode display,Press PROG/ENTR key for about 4 to 5
seconds.The unit will prompt CT Primary and then,press "UP" key till you get
display Device ID with following display.
To Next Page
Loading...
Need help?
General
