13
EXPANSION MODULE P875 - ANYBUS
®
INTERFACE
ANYBUS
®
FITTING
Push the Anybus® module (A) into the Trio Expansion Interface taking care to keep its base in contact with the PCB and align
guide slots (B) with the connector rails inside. Ensure that the moulded hooks (C) on the lower front edge of the Anybus®
module locate under the P875 PCB at the front.
When the module is ush with the face of the Trio Expansion Interface, tighten the two “Torx” head screws (D) to locate the
two lugs (E) and secure the Anybus® module.
To remove the module, reverse this procedure.
The P875 supports Anubus CC M30 Modules.
C
D
A
B
E
To Next Page
Loading...
