8
Operation
6. After the upgrade has completed, a screen appears to inform you that the
procedure to upgrade was successful. Click Finish to close the Firmware
Upgrade Utility.
7. Set up your KVM installation again.
Firmware Upgrade Utility-Failed
If the Upgrade Succeeded screen does not appear, it means that the
upgrade failed to complete successfully, in which case you should do the
following:
1. Disconnect the USB connectors on the KVM cables from the computer.
2. Press and hold the Remote Port Selector’s pushbutton. While still
pressing the pushbutton, reconnect the KVM cable’s USB connectors to
the computer.
3. Power on the B032-DUA2. It will now work with the factory default
firmware. Follow the steps in the Firmware Upgrade Utility section to
upgrade the firmware.
17-10-486-933633.indb 8 11/17/2017 2:44:37 PM
To Next Page
Loading...
