18
Electric shower
OPERATING THE SHOWER (fig.19)
When the electricity supply to the shower is
switched on at the isolating switch, the power
indicator will light up.
The START/STOP, HIGH, ECONOMY OR
COLD control buttons may be pressed to start
the shower.
NOTE: The shower starts as a default on the
HIGH setting if the START/STOP button is
used.
To stop the shower press the START/STOP
button and the phased shutdown will begin.
Water will cease to flow after approximately 5
seconds.
The HIGH setting allows the highest flow
achievable for your preferred temperature. This
setting should normally be regarded as optimum
shower performance throughout the year.
The ECONOMY setting uses less energy when
the ambient mains water temperature is high
during hot months.
NOTE: The preferred control position on
ECONOMY will give a different temperature to
the same position on HIGH.
The COLD setting is for cold water only.
Adjusting the temperature flow control at this
setting will only increase or decrease the flow of
the water from the shower head, it will not alter
the water temperature.
IMPORTANT: It will take a few seconds for the
temperature to stabilise once changes have
been made.
NOTE: If the stated flow rate required for the
unit cannot be met due to low water pressure,
it will be necessary to operate the unit on the
Economy setting during the warmer months
because of flow rate limitations entering the
unit.
Temperature Adjustment
The water temperature is altered by increasing or
decreasing the flow rate of the water through the
shower via the temperature flow control. Turning
the control anti-clockwise will increase the flow
of water through the shower and make the water
cooler. Turning it clockwise will decrease the
flow and make the water hotter.
Fig.19
Start/stop
button
Power
indicator
Cold
Economy
High
Hotter
Colder
To Next Page
Loading...
Need help?
General
