To Next PageTo Next Page
Need help?Do you have a question about the Triton T80 GSI and is the answer not in the manual?
General| Brand | Triton |
|---|---|
| Model | T80 GSI |
| Category | Bathroom Fixtures |
| Language | English |
Crucial safety warnings and precautions before installation.
Essential guidelines to read before proceeding with installation.
Key rules for general installation, plumbing, and electrical setup.
Compliance with water regulations and pipe flushing.
Compliance with wiring regulations and earthing.
Importance of the commissioning procedure for unit operation.
Recommendations for cleaning the product to maintain finish.
Power ratings, MCB, and fuse requirements for different models.
Water supply, pressure, temperature, and connection details.
Physical size and measurements of the shower unit.
Diagram showing possible locations for water and cable entry.
Mandatory earthing and circuit protection requirements.
Guidance on checking consumer units and selecting protection devices.
Table detailing cable capacity based on installation method.
Method for calculating approximate incoming cable size.
Guidelines for correct placement and vertical orientation.
Typical system layout showing connections and isolation.
Requirements for showerhead placement relative to bath/tray spillover.
Function of the PRD and precautions during operation/commissioning.
Using compression fittings and ensuring clear access.
Importance of an additional stopvalve for isolation.
Rules for routing and securing the supply cable.
Steps for mounting the unit and connecting water inlet.
How to create openings in the cover for pipe entry.
Final checks before fitting the cover, including control positions.
Steps for attaching the cover and securing it with screws.
Connecting the electrical cable to the terminal block.
Diagram illustrating the electrical connections within the unit.
Important notes on tightening screws and sleeving earth conductors.
Using supplied screws and fitting the cover securely.
Setting the power selector to the correct position before cover fitting.
Adjusting the stabiliser valve spindle.
Ensuring controls are set correctly before applying power.
Steps to flush the unit and remove air before normal use.
Basic operation of the start/stop button.
Understanding the COLD, ECONOMY, and HIGH settings.
How to adjust temperature by altering water flow.
Method to make the water hotter by reducing flow.
How the safety limit prevents overheating.
Operation of the non-resettable thermal cut-out device.
How the pressure switch adapts to varying water pressures.
Step-by-step guide for cleaning the inlet filter.
Causes and cures for the shower being inoperable.
Diagnosing and fixing water being too hot or too cool.
Addressing fluctuating temperatures and PRD activation.
Troubleshooting issues with the power selector or solenoid.
List of spare parts with corresponding part numbers.
Simplified instructions for basic shower operation.
Visual guide to using the power and temperature controls.
Details of the product guarantee and what is covered.
