EasyManuals Logo

Triton AS2000XT User Manual

Triton AS2000XT
28 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #4 background imageLoading...
Page #4 background image
Introduction
2
INTRODUCTION
This book contains all the necessary fitting and
operating instructions for your Triton Power
Shower. Please read them carefully.
The shower installation must be carried out by
suitably competent person and in sequence of
this instruction book.
Care taken during the installation will ensure a
long and trouble free life from your shower
IMPORTANT: All plumbing connections must
be completed BEFORE making the electrical
connections.
Please read through the whole of this book
before beginning your installation.
IMPORTANT: The fittings on the pipe inlet
elbows are of the push-in type. The pipework
must be cut with a pipe cutter and all burrs
and rough edges removed from the end of
the tube. The fittings can be used with
copper and plastic pipe.
Where chrome plated pipe is used, remove
the first 25mm of plating.
Note: The pump inside this product is rated 15
minutes on / 45 minutes off duty cycle.
SAFETY WARNINGS
a. Do not insert fingers into the push-in inlet
fittings. Doing so could cause injury.
b. Under no circumstances must this
product be connected to mains cold or
hot water supplies. Failure to comply will
invalidate the guarantee.
c. The shower MUST NOT be used if suspected
of being frozen.
d. The outlet of this appliance must not be
connected to any form of tap or fitting not
recommended by the manufacturer.
e. The sprayhead cartridge must be cleaned
regularly to remove scale and debris.
f. This appliance must be earthed.
g. Switch off immediately at the isolating
switch if water ceases to flow during use.
h. Do not operate the shower outside the
guidelines laid out in ‘site requirements’.
In the interest of electrical safety a 30mA
residual current device (RCD) should be
installed in all UK 230V electric and pumped
shower circuits. This may be part of the
consumer unit or a separate unit.
Replacement parts can be ordered from Triton
Customer Service. See ‘spare parts’ for details and part
numbers.
Due to continuous improvement and updating,
specification may be altered without prior notice.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Triton AS2000XT and is the answer not in the manual?

Triton AS2000XT Specifications

General IconGeneral
TypeElectric Shower
FinishWhite
MaterialPlastic
Maximum Pressure10 bar
MountingWall Mounted
Connection Size15mm
Activation MethodPush Button
Power SourceElectric
Water Entry PointsTop, Bottom, Back (Right Hand Side)
Cable Entry PointsTop, Bottom, Back (Right Hand Side)

Related product manuals