mini exposed sequential thermostatic mixer shower
11
COMMISSIONING
NOTE: The maximum temperature should be
checked on site to guarantee user safety.
Fit the temperature control knob. Secure the
knob in place with the retaining grub screw
(g.14).
Start the water ow by rotating the control knob.
Make sure that both the hot and cold water
supplies are fully open and at (or near to) their
design temperature and pressures and are
within the requirements as stated in the Site
Requiriements section.
Make sure the temperature control is at the
maximum temperature setting - rotated fully
anti-clockwise.
Allow the shower to run at the maximum
temperature setting until the water temperature
has stabilised. Rotate the temperature control
until your desired maximum showering
temperature is reached.
The mixer has a temperature stop to prevent
accidental rotation to higher temperatures. This
is adjustable to provide a maximum temperature
of 35°C – 40°C and should be checked on site to
guarantee user safety.
The following is recommended for domestic
installations but must be carried out for
commercial installations: Check the thermal shut
off facility of the mixer shower by performing a
thermal shut off test.
Shut off the cold supply. The ow from the mixer
shower should stop immediately or reduce to
a trickle in which case the water temperature
should be less than 43°C.
In either case there is no risk of scalding.
If, however, the temperature is above 43°C then
it is likely there is contamination in the mixer
shower stopping it from shutting off the hot
supply. In this case refer to the maintenance
section or contact Triton Customer Experience.
Fig.15
Fig.14
To Next Page
Loading...
Need help?
General
