490
5. Check to make sure that the selector drum is in the neutral position.
Perform the following operations:
• Output shaft - Installation
• Clutch - Installation
• Engine - Installation
• Fuel Tank - Installation
• Battery - Installation
• Seat - Installation
Gear Change Shaft and Selector Drum – Removal
Make sure the motorcycle is stabilised and adequately supported.
A correctly supported motorcycle will help prevent it from falling.
An unstable motorcycle may fall, causing injury to the operator or damage to the
motorcycle.
Perform the following operations:
• Seat - Removal
• Battery - Removal
• Fuel Tank - Removal
• Engine - Removal
• Gear Selector Forks - Removal
• Lower Crankcase - Removal
To Next Page
Loading...
